Part 2
Q. What will happen if DC supply is given on the primary of a transformer?
A:Mainly transformer has high inductance and low resistance.In case of DC supply there is no inductance ,only resistance will act in the electrical circuit. So high electrical current will flow through primary side of the transformer.So for this reason coil and insulation will burn out.Q. What are circuit breakers? What is bus-bar?
A: Isolators are mainly for switching purpose under off conditions but they cannot operate in live conditions .Actually they used for isolating the CBs for maintenance. Whereas CB gets activated under fault conditions according to the fault detected in live conditions.Q: If one lamp connects between two phases it will glow or not?
A: If the voltage between the two phase is equal to the lamp voltage then the lamp will glow. When the voltage difference is big it will damage the lamp and when the difference is smaller the lamp will glow depending on the type of lamp.Q: What is boucholz relay and the significance of it in to the transformer?
A :Boucholz relay is a device which is used for the protection of transformer from its internal faults, it is a gas based relay. whenever any internal fault occurs in a transformer, the boucholz relay at once gives a horn for some time, if the transformer is isolated from the circuit then it stop its sound itself other wise it trips the circuit by its own tripping mechanism.
Q: Motor load current is more than transformer load current. Justify
A:The motor has max load current compare to that of transformer because the motor consumes real power.. and the transformer is only producing the working flux and its not consuming.. hence the load current in the transformer is because of core loss so it is minimum.
No comments:
Post a Comment