electronics engineering objective questions
Q: Optocouplers combine -
A: In opto couplers the input signal is applied to ILED and the output takes from photo transistor. These are used to insolate the gate signals from the power circuit.
Q: The difference between indicated value and actual value of a quantity is known as
A: Dynamic error
Q: The principals of homogenity and super position are applied to
A: Linear time invariant systems
Q: In any transmitting antenna system , efficiency primarily depends upon
A: radiation resistance
Q : An instruction to set the carry flag in a computer can be classified as
A: arithmetic
basic electrical interview questions and answers
Part 3
Q:What is the difference between surge arrestor and lightning arrestor ?
A: Lightning Arrestor is installed outside and the effect of lightning is grounded,where as surge arrestor installed inside panels comprising of resistors which consumes the energy and nullify the effect of surge.
Q: What happen if we give 220 volts dc supply to d bulb or tube light ?
A: Bulbs [devices] for AC are designed to operate such that it offers high impedance to AC supply. Normally they have low resistance. When DC supply is applied, due to low resistance, the current through lamp would be so high that it may damage the bulb element.
Q: Which motor has high Starting Torque and Staring current DC motor, Induction motor or Synchronous motor ?
A: DC Series motor has high starting torque. We can not start the Induction motor and Synchronous motors on load, but can not start the DC series motor without load.
Subscribe to:
Posts (Atom)